Hardware
Discover hardware support for Focusrite products, including setup guides, troubleshooting tips, and firmware updates for audio interfaces and equipment.
- How to use DigiCo SD Series MADI outputs with the RedNet 6 or D64R
- Calibrating ISA Two's meters
- How do I connect my ISA One to my audio interface?
- What is Dante Redundancy?
- Using a Red in a redundant network
- Configuring a switch for Dante
- Can I sync my Dante system to an external clock?
- Using a Red Range interface with Dante
- Scarlett 16i16 4th Gen Standalone Mode setup
- Scarlett 18i16 4th Gen Standalone Mode setup
- Scarlett 18i20 4th Gen Standalone Mode setup
- How to connect three 4th Gen 18i20s using ADAT
- What are TS, TRS, and TRRS connectors?
- Digital I/O Modes
- Scarlett 4th Gen - Multichannel Auto Gain
- What should I set my clock source to on my Scarlett 4th Gen?
- Can I Damage My Equipment with Phantom Power (48V)?
- Scarlett Solo 4th Gen one or two input app compatibility
- Getting Started with Clarett 2Pre
- Getting Started with Clarett 8PreX
- Getting Started with Clarett 8Pre
- Getting Started with Clarett 4Pre
- Getting Started with Clarett
- Getting Started with Clarett USB
- Getting Started with your Scarlett 2i2 Studio 2nd Gen
- Getting Started with your Scarlett Solo Studio 2nd Gen
- Getting Started with your Scarlett 18i20 2nd Gen
- Getting Started with your Scarlett 18i8 2nd Gen
- Getting Started with your Scarlett 6i6 2nd Gen
- Getting Started with your Scarlett 2i4 2nd Gen