Where can I download Focusrite interface drivers

Applies to: All interfaces (Scarlett, Clarett, Saffire, iTrack)


Please note that you can download the drivers necessary from the Downloads section of our website, please use the following link and choose your product from the dropdown menu:


You'll notice that the download section for each product is also found within your Focusrite account, which you can log into via the main Focusrite website.

With our interfaces that use Mix Control or Focusrite Control, please note that the driver required for the unit (if applicable) is included within the installation for that control software. As such, only one installation is necessary for these interfaces, they include:

Clarett Range

Red Range

Saffire Range

Scarlett 6i6, 18i8 & 18i20 (including the discontinued 8i6 & 18i6)


With interfaces that do not use any control software, a standalone driver installation will be necessary, depending on your computer, and is available from the appropriate download page as mentioned above. These interfaces include:

iTrack Solo (Windows only)

Scarlett Solo, 2i2 & 2i4 (Windows only)

Saffire 6 USB 1.1

Saffire 6 USB 2.0 (Windows only)


The Scarlett range and Saffire 6 2.0 does not require a driver on Mac. In this case, whilst you will not need to install anything on a Mac to use the iTrack Solo, Scarlett Solo, 2i2 & 2i4 and Saffire 6 2.0, we would strongly advise still installing the appropriate control software for the larger units mentioned above as it will allow further control of the unit as well as facilitating any firmware update that may be available.


Was this article helpful?
28 out of 108 found this helpful
Have more questions? Submit a request


Didn't find what you were looking for?

Search again using our search tool.