Focusrite

Search

Help Centre

How do I use the inserts on Clarett OctoPre?

  • Updated

Applies to: 

Clarett OctoPre and Clarett+ OctoPre

Each analogue input on Clarett OctoPre and Clarett+ OctoPre has an unbalanced insert point that you can use to send the signal from the preamp to external effects, and then return the effected signal to the same channel.

The insert points are unbalanced, inputting and outputting via a single 6.35mm (¼″) TRS connector. 

A cross section of the insert, showing how the contacts aligns with a 6.35 millimeter or quarter inch jack: the tip aligns with send, the ring with return, and the sleeve with the ground.

You can split this into send and return with a TRS Y-splitter cable, or connect it to a device that also inputs and outputs via a single TRS connector.

A TRS Y splitter with one 6.35 millimeter or quarter inch TRS connector, splitting into two cables with two 6.35 millimeter or quarter inch TS connectors.
A TRS Y-splitter cable

To turn the insert point on for a channel, do the following:

  1. Press the INSERT button to the right of the meters. This will switch the INSERT/AIR buttons for each channel to insert mode.
    The main insert function button can be found on the front of the OctoPre, towards the right-hand side of the unit, on the right of the rectangular panel that contains the meters. There are four buttons on this panel, arranged in a square. The insert button is the top left of these four buttons.
  2. Beneath the gain dial for the channel, press the INSERT/AIR button to activate the insert. The LED will light to indicate that the insert is active.
    The insert button for each channel is found immediately below each channel's gain dial.

For more information, please refer to the user guides, which can be found in the Downloads section.

Related articles

Was this article helpful?
4 out of 18 found this helpful

We're sorry to hear that!

Please tell us why.