Why Is My Red Interface Not Showing Up On The Dante Network?

Applies to: Red 4Pre, Red 8Pre, Red 16Line

To use the interface with Dante Controller it must be set to Advanced Routing. To change this, access the Global Menu by pressing the Meter and Monitor buttons simultaneously. Move the Monitor encoder (encoder on the right) and select Routing. Press the Monitor Encoder to change it from Auto Routing to Advanced Routing. Once this is done you will be able to use the interface on the Dante Network.

Was this article helpful?
4 out of 11 found this helpful
Have more questions? Submit a request


Didn't find what you were looking for?

Search again using our search tool.