Can the second network port on the Red 4Pre/8Pre/16Line be used as part of a redundant network setup?

Applies to: Red 4Pre/8Pre/16Line

Yes - the Dante ports on the Red Range can be set to either 'Switched' or 'Redundant' mode using Dante Controller, depending on your network requirements.

To enable this, in Dante Controller go to Device > Device View and then select your Red interface from the list. Then, go to the Network Config tab and select 'Redundant' or 'Switched' as required (you'll need to restart the interface after selecting that option for the change to take effect).


Was this article helpful?
0 out of 1 found this helpful
Have more questions? Submit a request


Didn't find what you were looking for?

Search again using our search tool.