This applies to the ISA Two
To calibrate the meters on your ISA Two to your DAW, follow the instructions below:
1. Send a test tone to the line input of ISA Two. This can be achieved using the tone generator in your DAW, and the line output of your interface.
2. Connect the line output of ISA Two to a line input of your interface.
3. Monitor the input level in your DAW, and adjust the gain of ISA Two until the DAW input level reads 0dBFS.
4. Adjust the calibration knob on the rear panel of ISA Two until the ISA Two's meter value matches that of your DAW.
Please note that the meter of ISA Two has an adjustment range of +16 to +24 dBu = 0dBFS. If the maximum input level of your interface falls outside of this range, you will need to calibrate your system with an offset. i.e. If your interface has a maximum input level of +14 dBu, you would need to calibrate the meter of ISA Two such that when it reads -2 dBFS, its output level would actually correspond to the maximum input level of the interface.
As always, if you have any questions or concerns you can get in touch with us through our Support Contact Form and we will be happy to help.