I get a loud pop through my speakers when I turn my VoiceMaster Pro on and off. Is this normal?

Article applies to: Platinum VoiceMaster Pro.

This is normal and you will find that any class A pre amp does this (unless there is a relay circuit to delay the switching of the output - normally found in active speakers). The noise is caused by all of the components suddenly being charged by a DC so there is no way to prevent it other than not turning the unit on. With any recording set up it is advisable to turn things on in the order of the signal chain - definitely amp/monitors last. Make sure theVoiceMaster Pro is the first thing you turn on and the last thing you turn on in your set up.

Was this article helpful?
0 out of 1 found this helpful
Have more questions? Submit a request


Didn't find what you were looking for?

Search again using our search tool.